Dell™ PowerConnect™ / is provided with pre-defined not set to auto -negotiation, both the switching port and the NIC must be manually set with the. Office Manuals and free pdf instructions. Find the office and computer equipment manual you need at ManualsOnline. Dell Switch User Manual. Page 1. Manufacturer: Dell, Model: , Type of document: User manual, Category: Switch, Number of pages:
|Published (Last):||5 October 2014|
|PDF File Size:||12.40 Mb|
|ePub File Size:||13.53 Mb|
|Price:||Free* [*Free Regsitration Required]|
Configuring System Information To open the Reset page: Viewing Rmon Information Viewing History Control Statistics The About page contain the device name, the software release number, powerconnecr Dell copyright information.
D-Cache 16 KB, linesize The service will start automatically when a host key is generated. Configuring Switch Infor mation Back Disabled Global Configuration Mmanual Viewing The Versions Page To configure user name and privilege level, enter the command at the system prompt as shown in the configuration example:.
Configuring the PowerConnect 3324/3348 Switch
Devices supporting SNMP run local software agent. Configures the maximum broadcast rate. The RMON alarm is added, and the device is updated. The device times out after 35 seconds if no selection is made.
The MIB presents the variables controlled by the agent. User Exec Mode Remote Management Access A necessary precondition for this is the unmistakable, legible character of an instruction. The Bridge Multicast Group page opens. Page 71 Enter the command Telnet and the device IP address. Contents 9 Multicast F orwarding Support.
The default host name is console unless it has been modified during initial configuration. The connection is done with the IP address defined on the device. Multicast Forwarding Support Multicast forwarding allows a single packet to be forwarded to multiple destinations. The Local User Database page opens.
Link Aggregation lag The device times out after 35 seconds if no selection is made. Configuring Security Passwords The security passwords can be configured for the following services: To open the Log File Table page: Indicates that the port is disconnected.
Queue priorities are defined by the powerclnnect length. To open the QoS Interface Settings page: At the console prompt, type Enable. Defining Lag Membership Opens the About page.
Page Hubs and switches are deliberately wired the opposite way end stations are wired, so 3384 when a hub or switch is connected to an end station, a straight through Ethernet cable can be used, and the pairs match up properly. Description Displays classes of dynamically created entries in the bridge-forwarding database.
Configuring the PowerConnect / Switch: Dell PowerConnect / User’s Guide
VLAN or multicast address. If trust mode is to be disabled on the specific interface, check the Disable “Trust” Assigning Authentication Profiles In accordance with the law, a customer can receive an instruction in non-paper form; lately graphic and electronic forms of the manuals, as well as instructional videos have been majorly used.
Bracknell International Access Code: To switch off all equipment, the power supply cable is removed from the power supply socket. Enter the command Telnet and the device IP address. Console config-line enable authentication default Console config-line login authentication default Console config-line exit Console config ip http authentication radius local Console config ip https authentication radius local Console config exit Console show authentication methods Login Authentication Method Powsrconnect Default: Instructions for setting up the device and hardware are provided in the preceding sections.